RCA Circ-Lite Drive-In Movie Speaker Lighted 12-110 Volt LED Junction Box Kit
Do it yourself Drive-In Movie Speaker Lighted 12-110 Volt LED Junction Box kit that fits RCA Circ-Lite junction boxes.
Includes 5-LED 12 volt/110 volt bulb and socket
On/off power switch that operates the LED light
5 position terminal block
The switch is mounted to the bottom of the junction box casting as shown in the pictures
LED light bulb illuminates the red diffuser lens and top of the speaker pole
NOTE: Junction box bottom is not included, used for illustration
We're also supplying a 3-foot 5.5MM extension power supply cable that attaches to the LED 5.5MM connector and down the pole to power supply. This LED bulb requires 12 volts to power up. We're supplying a 3-foot 110 volt to 12 volt wall jack converter. Keep in mind, our set-up could operate on any 12 volt applications, such as your car cigarette lighter. Perfect addition for your classic car shows, recreational room, around the pool, or even man cave, Detroit Diecast stickers can be removed.
Installation Guide:
Step #1: Start off by removing the female spade terminals from the on/off switch. Carefully pull the female spade terminal off the on/off switch. Make note of wiring orientation for reassembly.
Step #2: Unscrew the plastic retaining nut off the switch.
Step #3: Insert the switch through the existing pre-drilled hole as shown in illustration. The pre-drilled hole might need deburring excessive flashing prior to installing the switch.
Step #4: Tighten the plastic retaining nut with needle nose pillars. Be careful not to over torque plastic retaining nut.
Step #5: Attached the terminal strip to the base of the junction box with the machined screws provided.
Step #6: Plug in power supply/extension cord to test the system. Push the red button to the flush position. The red button will be close to flush in the on position.